A1100 | Anti bleed Additive

Harmonization Code : 3910.00.00.90 | Silicones in Primary Forms; Others

Main features

0.5%-1% wt
Metal surfaces
Excellent bleed control

Product Description

A-1100 is a proprietary non-halogenated additive designed to reduce resin bleed out on a variety of surfaces with minimal or no affect on the adhesion properties of the formulation. It shows excellent results when used in non-metal filled systems after reducing bleed. It is co-curable in free-radical polymerization. It also can enhance the rheological properties of various filled adhesives.

A-1100 is recommended for use as an additive to reduce resin bleed out specifically on metal surfaces and has more acid functionality per molecule then A-1050. The recommended addition of the A-1100 to a formulation is between 0.5% - 1% weight percent of resin. It shows superior bleed control in formulations that contain non-metal fillers such as silica.

Specifications

Technical Specifications

General Properties
Appearance Appearance Appearance at room temperature.	Yellow liquid
Density (g)	1.01 g/cm3
Physical Properties
Viscosity Viscosity Viscosity is a measurement of a fluid’s resistance to flow. Viscosity is commonly measured in centiPoise (cP). One cP is defined as the viscosity of water and all other viscosities are derived from this base. MPa is another common unit with a 1:1 conversion to cP. A product like honey would have a much higher viscosity -around 10,000 cPs- compared to water. As a result, honey would flow much slower out of a tipped glass than water would. The viscosity of a material can be decreased with an increase in temperature in order to better suit an application	475 mPa.s
Thermal Properties
Flash Point Flash Point The flashpoint of a solvent is the lowest possible temperature at which it can vaporize to form an ignitable vapor. Flashpoint is often confused with “autoignition temperature”, which is the temperature at which a solvent ignites without an ignition source.	146 °C