Shopping cart overview
Your Cart is currently empty.

Shopping cart overview

Your Cart is currently empty.

LOCTITE EDAG PF 407A E&C

Harmonization Code : 3506.91.90.99 | Prepared glues and other prepared adhesives, not elsewhere specified or included; products suitable for use as glues or adhesives, put up for retail sale as glues or adhesives, not exceeding a net weight of 1 kg ; Adhesives based on polymers of headings 3901 to 3913 or on rubber; Other ; Other

Main features

Print Contact areas
Good screen residence time
Carbon filled

Product Description

LOCTITE EDAG PF 407A E&C is a carbon filled ink with inert pigment that can be used to print contact areas on flexible circuits.

LOCTITE EDAG PF 407A is a screen printable, conductive, carbon filled thermoplastic with good screen residence time that is flexible for low temperature drying cycles.

LOCTITE EDAG PF 407A is typically used for printed resistors, membrane touch switches. keyboards, heating elements, flexible circuits and ESD protection. It can continuously operate at a temperature of 105°C and has been successfully used on Polyester, Polyimide, Polycarbonate, paper and cardboard substrates.

Drying Cycle

30 minutes @ 90°C or
15 minutes @ 120°C

Technical Specifications

General Properties

Bulk Density

Bulk Density
The amount of a certain product that comes in a bulk.

1,12 g/cm3

Shelf Life Shelf Life Shelf life is the amount of time after manufacturing that a product is guaranteed to retain its properties. It differs vastly per product and it is based on temperature and storage conditions. The properties can be guaranteed for the temperature and time range indicated on the TDS since those are the ones tested to be the best for the product.
Shelf Life @ 25°C	365 days

Mechanical Properties

Viscosity

Viscosity
Viscosity is a measurement of a fluid’s resistance to flow.

Viscosity is commonly measured in centiPoise (cP). One cP is defined as
the viscosity of water and all other viscosities are derived from this base. MPa is another common unit with a 1:1 conversion to cP.

A product like honey would have a much higher viscosity -around 10,000 cPs-
compared to water. As a result, honey would flow much slower out of a tipped glass than
water would.

The viscosity of a material can be decreased with an increase in temperature in
order to better suit an application

Viscosity

35,000 mPa.s