LOCTITE EDAG PM 406V1 E&C

Harmonization Code : 3506.91.90.99 |   Prepared glues and other prepared adhesives, not elsewhere specified or included; products suitable for use as glues or adhesives, put up for retail sale as glues or adhesives, not exceeding a net weight of 1 kg ; Adhesives based on polymers of headings 3901 to 3913 or on rubber; Other ; Other
Main features
  • High conductivity
  • High solids content
  • Hot air dry cure

Product Description

LOCTITE EDAG PM406V1 E&C is a screen printable, conductive ink formulated to have very high conductivity and solids content. It can be used on PET, paper and PVC substrates.

LOCTITE EDAG PM406V1 E&C can operate in operating temperature up to 100°C that has high solids content and dries fast. It is typically used for printed circuitry, RFID and other conductive circuits.

Recommended Drying Cycle

  • 30 minutes @ 90°C or
  • 15 minutes @ 120°C
Product Family
PM406V1  
1.5Kg Jar

Catalog Product

Unlike other products we offer, the products listed on this page cannot currently be ordered directly from the website.
Packaging
TDS, SDS & Technical documents

Technical Specifications

General Properties
Density (g) 3 g/cm3
Solids 79 %
Physical Properties
Viscosity
Viscosity
Viscosity is a measurement of a fluid’s resistance to flow.

Viscosity is commonly measured in centiPoise (cP). One cP is defined as
the viscosity of water and all other viscosities are derived from this base. MPa is another common unit with a 1:1 conversion to cP.

A product like honey would have a much higher viscosity -around 10,000 cPs-
compared to water. As a result, honey would flow much slower out of a tipped glass than
water would.

The viscosity of a material can be decreased with an increase in temperature in
order to better suit an application
 21,600 mPa.s