HumiSeal Thinner 73

Harmonization Code : 3814001000 |  
Main features
  • RoHS Directive 2015/863/EU compliant
  • Ensures proper viscosity adjustment
  • For use with 1B73 and 1A20

Product Description

HumiSeal Thinners are blends of solvents, formulated to maintain the original system balance when added to the correct coating type. These HumiSeal® Thinners are in full compliance with the RoHS  Directive 2015/863/EU. 

Product Key Features

  • Ensures proper viscosity adjustment for HumiSeal conformal coatings
  • Fully compliant with  RoHS Directive 2015/863/EU. 

Applications

  • Adjusting viscosity of HumiSeal 1B73 and 1A20 conformal coatings.
Product Family
HS-T73  
20-liter 5-liter 1-liter

Catalog Product

Unlike other products we offer, the products listed on this page cannot currently be ordered directly from the website.
Shipping in 6 weeks
Packaging
TDS, SDS & Technical documents

Technical Specifications

General Properties
Specific Gravity
Specific Gravity
Specific gravity (SG) is the ratio of the density of a substance to the density of a reference substance; equivalently, it is the ratio of the mass of a substance to the mass of a reference substance for the same given volume.

For liquids, the reference substance is almost always water (1), while for gases, it is air (1.18) at room temperature. Specific gravity is unitless.
 0.88
Vapor Density 4.0
Vapor Pressure 0.0108761 kg/cm2
Thermal Properties
Boiling Point
Boiling Point
The amount of degree’s needed to reach in order to make the substance boil.
 127 °C
Flash Point
Flash Point
The flashpoint of a solvent is the lowest possible temperature at which it can vaporize to form an ignitable vapor.

Flashpoint is often confused with “autoignition temperature”, which is the temperature at which a solvent ignites without an ignition source.
 27 °C

Additional Information

Directions for Use   

Add HumiSeal® Thinner to a compatible coating until the desired viscosity is obtained.  

Handling Precautions  

HumiSeal® Thinners are flammable and the following standard safety precautions should be observed:  

  • Use only in well ventilated areas.   
  • Protective gloves and goggles should be worn.   
  • In case of prolonged skin contact, wash with water.   
  • In case of eye contact, flush with water and contact physician.   
  • Avoid prolonged breathing of vapors.  
  • Unused portions of HumiSeal® products must be disposed of in strict compliance with Local, State, and  Federal laws governing such matters.   
  • Consult the Safety Data Sheet (SDS) for more specific product information.