HumiSeal Thinner 903

Harmonization Code : 3814001000 |  
Main features
  • Slower evaporation rate
  • Smoother flow
  • Better leveling

Product Description

Consider using HumiSeal Thinner 903 to adjust conformal coating viscosity when improved flow and leveling are required. Thinner 903 has moderate evaporation rate (~1) and higher boiling point, meaning the solvent stays wet longer, which helps coatings self-level for a smoother finish.

Product Key Features

  • Slower‑evaporating
  • Ideal for smoother flow and better leveling on these conformal coatings

Applications

Product Family
HS-T903  
20-liter 5-liter 1-liter

Catalog Product

Unlike other products we offer, the products listed on this page cannot currently be ordered directly from the website.
Shipping in 6 weeks
Packaging
TDS, SDS & Technical documents

Technical Specifications

General Properties
Color
Color
The color
 Clear
Specific Gravity
Specific Gravity
Specific gravity (SG) is the ratio of the density of a substance to the density of a reference substance; equivalently, it is the ratio of the mass of a substance to the mass of a reference substance for the same given volume.

For liquids, the reference substance is almost always water (1), while for gases, it is air (1.18) at room temperature. Specific gravity is unitless.
 0.78
Vapor Density 3.7
Vapor Pressure 34 mmHg
Thermal Properties
Boiling Point
Boiling Point
The amount of degree’s needed to reach in order to make the substance boil.
 115 °C
Flash Point
Flash Point
The flashpoint of a solvent is the lowest possible temperature at which it can vaporize to form an ignitable vapor.

Flashpoint is often confused with “autoignition temperature”, which is the temperature at which a solvent ignites without an ignition source.
 -1 °C

Additional Information

Directions for Use

Add HumiSeal® Thinner to a compatible coating until the desired viscosity is obtained. 

Handling Precautions

HumiSeal® Thinners are flammable and the following standard safety precautions should be observed:   

  • Use only in well ventilated areas.   
  • Protective gloves and goggles should be worn.   
  • In case of prolonged skin contact, wash with water.   
  • In case of eye contact, flush with water and contact physician.   
  • Avoid prolonged breathing of vapors.  
  • Unused portions of HumiSeal® products must be disposed of in strict compliance with Local, State, and Federal laws governing such matters.   
  • Consult the Material Safety Data Sheet (MSDS/SDS) for more specific product information.