Only signed in users will see discount codes and have complete access to product lines, datasheets and pricelists
Aculon's 905 Specialty Cleaner is a water based cleaner designed for use on almost all metallic and oxide containing surfaces. It is not designed for use on copper, brass, tin, or silver. While not designed specifically for glass or ceramic, this cleaner should not harm those substrates. This cleaner is used to get the substrate to a water break free condition to enhance the adhesion of Aculon's coatings.
Parts Must be sufficiently clean prior to treatment for proper bonding and effective application.
Option - Wipe Clean Saturate an absorbent cloth with Aculon 905 Cleaner. Use the saturated cloth/towelette to wipe area that requires treatment. Ensure that all areas are wiped with moderate force for 1 - 3 minutes. Sufficient contact time and mechanical abrasion is critical for successful treatment. Rinse off the remaining cleaner with copious amounts of water. Rinse with water for at least 60 seconds. For best results, use deionized water. Option - Dip Clean Utilize a dip bath (stainless steel or glass recommended) sufficient to fully submerge the areas of the part requiring treatment. Dilute the provided cleaner by mixing 1 part of cleaner with 4 parts of water by volume. Heat the cleaner to 40° - 50°C. Submerge the part for 5 minutes. Adding sonication or mixing of the cleaner will improve the effectiveness of the cleaner. Remove part and rinse with deionized water. While rinsing, check for free sheeting of the water as an indication of a water break free condition. The water should not bead up in the areas that were cleaned. Allow to dry. For best results, blow dry the part with clean, dry compressed air and treat the substrate with your selected treatment immediately.