LOCTITE EDAG PM 406V1 E&C
- High conductivity
- High solids content
- Hot air dry cure
LOCTITE EDAG PM406V1 E&C is a screen printable, conductive ink formulated to have very high conductivity and solids content. It can be used on PET, paper and PVC substrates.
LOCTITE EDAG PM406V1 E&C can operate in operating temperature up to 100°C that has high solids content and dries fast. It is typically used for printed circuitry, RFID and other conductive circuits.
Recommended Drying Cycle
- 30 minutes @ 90°C or
- 15 minutes @ 120°C
|Density (g)||3 g/cm3|
| Viscosity |
Viscosity is a measurement of a fluid’s resistance to flow.
Viscosity is commonly measured in centiPoise (cP). One cP is defined as
the viscosity of water and all other viscosities are derived from this base. MPa is another common unit with a 1:1 conversion to cP.
A product like honey would have a much higher viscosity -around 10,000 cPs-
compared to water. As a result, honey would flow much slower out of a tipped glass than
The viscosity of a material can be decreased with an increase in temperature in
order to better suit an application